Racor Water Detector

Part No: RK20126

Racor Water Detector2″ Gauge Type Water Detection Module, with light and audio warning. Red “DRAIN” lamp illuminates continuously and horn sounds momentarily when water is detected. Initial power-up self diagnosis feature and circuit protection included.

Plastic case, satin black dial with white lettering.

1 Probe Included. Power draw for 12 vdc = 3 milliamps, 24 vdc = 13 milliamps.


Racor Water Probe

Part No: RK21069

Additional probe for Racor Water Detector Kit. (Use on second filter unit.)


Racor Turbine Series Filters

Turbine Series FiltersThree-stage filter system removes nearly all the water and 100% of harmful solids in fuel. The primary stage centrifuges the fuel, which send the large particulate matter and water droplets down to the sediment bowl.

The second stage uses a coalescing ring, which causes the remaining water to form into droplets and fall into the sediment bowl while the dry fuel continues upward.

The third stage is an Aquabloc® filter, which removes the remaining minute grit and water. A built in check valve keeps the fuel from draining back into your tank. The MA model is US Coast Guard Approved with a heat shield for application in a marine environment.

Available in 2, 10, 30 MICRON filters.

Part No: RAC500MA

Fuel flow is 60 GPH and the inlet/outlet port size is 3/4″-16 UNF which requires two installation fittings to adapt to your fuel line fitting size. This unit also requires drain valves to be added if desired.

Part No: RAC900MA

Fuel flow is 90 GPH and the inlet/outlet port size is 7/8″-14 UNF which requires two installation fittings to adapt to your fuel line fitting size. This unit also requires drain valves to be added if desired.

Part No: RAC1000MA

Fuel flow is 180 GPH and the inlet/outlet port size is 7/8″-14 UNF which requires two installation fittings to adapt to your fuel line fitting size. This unit also requires drain valves to be added if desired.


Racor Turbine Series Fuel Heater

The Racor Turbine Series comes available with a powerful heater situated directly below the filter element to assist with cold starting. Thermostats are standard to meet the requirements of today’s advanced electronic engines. They begin to work in just a few moments and place minimal demand on the battery. The heaters are available installed in assembly upon order or as a retrofit kit.


Racor Replacement Elements

Racor Aquabloc® elements are available in 2, 10, and 30 micron protection ratings. The lower the micron rating, the finer the filtration. Lower micron ratings should be considered when there is no additional downstream filtration/

Thirty-micron (PM) is recommended when the Turbine Series will function as water separator and promary filter.

The ten-micron (TM) can be used for primary or secondary/final filtration depending on the engine and/or the application.

The two-micron element (SM) is secondary final/filtration. Ultimately, the micron rating preferred will be a function of fuel quality, operating climates and maintenance schedules.

With an Aquabloc® replacement element, you get a complete kit with all the seals you need. And not just any seals, but specifically formulated, Racor-engineered seals that ensure your Racor Filter/Separator will be at optimim lebels of performance.

Filters For Turbine SeriesRacor turbine replacement elements for 500 Series
Racor turbine replacement elements for 900 Series
Racor turbine replacement elements for 1000 Series

Call for case pricing.


Marine Fuel Shut Off Valve

1/4″ NPT. Shut off Drain valve for 500, 900 or 1000MA filter.

Visit The Store

Talk to a Rep

Contact Us!